J Korean Acad Prosthodont.  2004 Feb;42(1):1-10.

A novel 3D scan method to quantify teeth wear

Affiliations
  • 1Department of Prosthodontics, Division of Dentistry, Graduate School, Kyung Hee University.
  • 2Samsung Medical Center, College of Medicine, Sungkyunkwan University.

Abstract

STATEMENT OF PROBLEM: Tooth wear is physiological phenomenon. Ninety-seven percent of normal people have tooth wear and about 7% has pathologic teeth wear. If we know the amount of tooth surface loss caused by pathologic tooth wear, we may restore it ideally. PURPOSE: Recently, measurement of tooth wear by using 3D scan has been increasing. Therefore, we need to know how accurate 3D scan is. Past accuracy test on 3D scan was about linear change, but as we know that tooth wear is volume change. Thus, the purpose of this study is to know how accurate 3D scan is. MATERIAL AND METHODS: For accuracy test of 3D scanner, volume values measured by 3D scanner and micro-balance were compared. For test I, preliminary, 3 ball samples and 3 circular cones were made with pattern resin. For test II, 10 teeth shape rubber samples were used. RESULTS AND CONCLUSION: 1. The result of the accuracy test on 3D scan with 3 ball samples and 3 circular cones made of pattern resin has no significant difference(p<0.05). 2. The result of the accuracy test on 3D scan with 10 samples of tooth shape rubber has no significant difference(p<0.05). As a result, we may concluded the analysis of quantifying tooth wear used by 3D scan is useful in the clinic.

Keyword

3D Scan; Tooth wear; Volume change

MeSH Terms

Physiological Phenomena
Rubber
Tooth Wear
Tooth*
Rubber
Full Text Links
  • JKAP
Actions
Cited
CITED
export Copy
Close
Share
  • Twitter
  • Facebook
Similar articles
Copyright © 2024 by Korean Association of Medical Journal Editors. All rights reserved.     E-mail: koreamed@kamje.or.kr