Skip Navigation
Skip to contents
Results by Year

View Wide

Filter

ARTICLE TYPE

more+
SELECT FILTER
 
Close

PUBLICATION DATE

113 results
Display

Immediate fixed partial denture after tooth extraction in patients with systemic diseases: A clinical report

Kang HS, Lee SY

For patients with systemic diseases who face difficulties visiting dental clinics, wearing fixed partial denture in the anterior region on the same day of tooth extraction can reduce the total...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Rehabilitation of maxillary partial edentulous patients using implant assisted removable partial denture

Lee BR, Kim JH

Treatment options for partially edentulous patients are fixed partial denture, removable partial denture and implant supported fixed partial denture. In case of a patient with a few remaining teeth, removable...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Resin-bonded fixed partial denture using In-Ceram and Targis-Ventris system

Cha YJ, Yang JH

  • KMID: 2136373
  • J Korean Acad Prosthodont.
  • 2000 Jun;38(3):375-381.
Resin-bonded fixed partial denture using In-Ceram or Targis-Vectris system allows conservative replacement of missing maxillary lateral incisor, but sufficient clinical crown length and adequate occlusal clearance are necessary for restoration....
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Modified soft tissue cast for fixed partial denture: a technique

Patil PG

In process of fabrication of a fixed partial denture, dies are trimmed to expose margins of the preparations. The need for the soft tissue cast is quite evident as the...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
An implant-supported removable partial denture for a patient with post-inflammatory scar contracture caused by burn complications: a clinical report

Kim JH, Lee JH

The scars and contracture around the oral-facial region may cause difficulty in prosthodontic treatment to restore esthetics and function for the patients, who suffered severe burns. This article presents a...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Accidental ingestion of a fixed partial denture during general anesthesia: A case report

Kim KN, Kim KS, Lee HJ, Oh YN

Swallowing a foreign body of dental origin is a rare occurrence; but, it can be dangerous if the foreign body is large, sharp, and pointed. We report a case in...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Finite element analysis of stresses and deflections induced by fixed partial denture using endosteal implant

Choi SH, Chung CH

  • KMID: 1694448
  • J Korean Acad Prosthodont.
  • 1991 Jun;29(1):233-248.
No abstract available.
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Resin bonded fixed prosthesis for single tooth restoration: A case report

Kim E, Lee J

In the case of single tooth replacement, a fixed prosthesis or a dental implant is the treatment option commonly selected as first choice. However, any amount of sound tooth structure...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Trend analysis of prosthodontic treatment modality between 2005 and 2008 in Seoul National University Dental Hospital

Li H, Lee JB, Liu H, Han JS, Yang JH, Koak JY, Heo SJ

PURPOSE: The aim of this article is to analyze the preference for treatment modality of dentists. MATERIAL AND METHODS: Data of 20,038 patients was involved. Data analysis were done by distribution...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Combined application of roll flap and combination onlay-interpositional graft to enhance esthetics of maxillary anterior fixed partial denture: A case report

Oh SC, Cha DH, Lee JI

In the maxillary anterior region, reconstruction of the localized alveolar ridge defect is very important in enhancing the esthetics of fixed partial denture. A 40-year-old female patient presented with a...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Clinical perspectives on 2-unit cantilevered resin-bonded fixed partial denture

Yi YJ, Choi LR, Park CJ

  • KMID: 1959472
  • J Korean Acad Prosthodont.
  • 2003 Feb;41(1):81-88.
Resin-bonded bridge has been an alternative to conventional bridge, since resin-bonded bridge has many attractive advantages such as minimal tooth preparation, short chair time and low cost over conventional bridge....
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Effect of prosthetic designs and alveolar bone conditions on stress distribution in fixed partial dentures with pier abutments

Cho W, Kim CS, Jeon YC, Jeong CM

  • KMID: 2321765
  • J Korean Acad Prosthodont.
  • 2009 Jul;47(3):328-334.
STATEMENT OF PROBLEM: Pier abutments act as a Class I fulcrum lever system when the teeth are incorporated in a fixed partial denture with rigid connectors. Therefore non-rigid connector incorporated...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Finite element stress analysis on the supporting tissues depending upon the position of osseointegrated implants supporting fixed bridges

Yoon DJ, Shin SW, Suh KW

  • KMID: 1695917
  • J Korean Acad Prosthodont.
  • 1993 Mar;31(1):87-99.
No abstract available.
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Patients' knowledge and awareness of dental implants in a Turkish subpopulation

Ozcakir Tomruk C, Ozkurt-Kayahan Z, Sencift K

PURPOSE: The purpose of this study was to evaluate the patients' knowledge on dental implants in a Turkish subpopulation. MATERIALS AND METHODS: Five hundred twenty seven Turkish adults referred to Yeditepe...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
The optimal design of connectors in all ceramic fixed partial dentures manufactured from alumina tape

Oh NS, Kim HS, Lee MH, Lee KW

  • KMID: 2195767
  • J Korean Acad Prosthodont.
  • 2004 Apr;42(2):125-132.
STATEMENTS OF PROBLEM: All ceramic fixed partial denture cores can be made by the slip casting method and the advanced alumina tape method. The fracture resistance of these core connector...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Influence of the amount of tooth surface preparation on the shear bond strength of zirconia cantilever single-retainer resin-bonded fixed partial denture

Sillam CE, Cetik S, Ha TH, Atash R

PURPOSE: Conventional resin-bonded fixed partial dentures (RBFPDs) are usually made with a two-retainer design. Unlike conventional RBFPDs, cantilever resin-bonded fixed partial dentures (Cantilever RBFPDs) are, for their part, made with...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Autotransplantation of the missing tooth: the report of cases

Park JH, Kim WT, Min BJ, Lee WH, Lee JG

  • KMID: 1961154
  • J Korean Assoc Oral Maxillofac Surg.
  • 2002 Dec;28(6):480-483.
Treatments for restoring the function and esthetics of missing teeth include fixed bridge, partial denture, orthodontic movement, implantation and autotransplantation. However, there is no absolute indications for each techniques. Due...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Time-dependent deformation of polymer-based provisional crown and fixed partial denture materials

Pae A, Jeong MS, Kim SH

  • KMID: 2000698
  • J Korean Acad Prosthodont.
  • 2005 Dec;43(6):717-726.
STATEMENT OF PROBLEM: One of the common problems of provisional crown and fixed partial denture materials is that when they are subjected to constant loads for a long period of...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
Fracture strength between different connector designs of zirconia core for posterior fixed partial dentures manufactured with CAD/CAM system

Seo JY, Park IN, Lee KW

  • KMID: 1906950
  • J Korean Acad Prosthodont.
  • 2006 Feb;44(1):29-39.
Statements of problem: Zirconia core is used for posterior fixed partial dentures because it's good mechanical properties. Stress is concentrated on connectors in fixed partial dentures, so the proper design...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
A Comparison Of Load Transfer In Screw-And Cement-Retained Implant Fixed Partial Denture Designs

Lee JH, Kim CW, Kim YS

  • KMID: 2127532
  • J Korean Acad Prosthodont.
  • 2001 Apr;39(2):125-145.
To compare the stress distribution patterns between cement-retained and screw-retained implant supported fixed prostheses according to four different abutment types, a three dimensional finite element analysis was performed. The hypothetical...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close

Go to Top

Copyright © 2024 by Korean Association of Medical Journal Editors. All rights reserved.     E-mail: koreamed@kamje.or.kr